Advertisement
Alcohol / Cleaner
N
O
*Clean the area of the windshield where the antenna will be mounted with an alcohol-based glass cleaning solution.
T
Ensure the glass surface is completely dry.
E
*Mount the dipole antenna to the windshield approximately 0.5" below the mirror's lowest attachment point and/or any wind-
shield electronic gridwork, as shown above. Remove protective backing. Press firmly to ensure a good glass to adhesive bond.
Trim Tool, Wire Cutter
N
*Wrap the antenna cable with (3) pieces of supplied black
O
foam tape at the distances shown to the right to ensure
T
that the antenna will stay in place after routing.
E
*Route the antenna cable vertically on the right hand side
of the mirror mount up to the headliner. Tuck the cable
behind the headliner and down the "A" pillar. Use (3)
small wire ties to secure the antenna cable to the factory
harness located within the "A" pillar. Trim off excess
wire ties.
WARNING! Air Bag system interference hazard.
!
DO NOT secure antenna cable to the Air Bag com-
ponents. Damage to the vehicle's Air Bag system
may occur which could result in serious physical
injury.
CAUTION! If the vehicle is equipped with a sunroof,
be careful not to place the wire ties around the drain
tube or the sunroof may not drain properly.
HYUNDAI Genuine Accessories (Installation)
2
Revision Date
9"
5/2/2012
9"
Foam Tape
1
8"
Page 8 of 29
Advertisement
