Advertisement
Plastic Harness
Before Relocation
Protector
Note: Relay may not be mounted in this location on some vehicles. If relay is not mounted
as shown above, skip this step.
Wire Cutter
N
*Locate and remove the relay assembly, attached to the back side of the gray plastic wire harness protector, by sliding toward the
O
center of the vehicle. The relay is located to the left of the MDPS Control Module, as shown above.
T
*Wrap the relay with (1) supplied gray foam tape, as shown above. Position and secure the foam wrapped relay assembly to the
E
factory wire harness with (1) supplied large wire tie, as shown above. Trim off excess wire tie.
Antenna
16-Pin 24-Pin 10-Pin
1/4" Drive Ratchet, 13 mm 1/4" Drive Socket, 1/4" Torque Wrench, Wire Cutter, 1/4" Drive 6" Extension
*Route the antenna cable past the left side of the dashboard and down to the vehicle dash wall.
N
*Plug the wire harness and the antenna cable into the remote start module before mounting.
O
T
*Ensure all connectors are properly locked into position.
E
*Secure the remote start module to the factory clutch pedal location, on the vehicle dash wall, to the left of the steering column
with (1) supplied M8 bolt and (1) supplied large wire tie, as shown above. Trim off excess wire tie.
*Using torque wrench, torque to 15 lb-ft (21 Nm).
*Secure the excess antenna cable to the available module mounting hole with (1) small wire tie, as shown above.
Trim off excess wire tie.
CAUTION! Be careful not to bend/damage any of the terminals inside the remote start module.
HYUNDAI Genuine Accessories (Installation)
MDPS Control Module
Slide relay assembly toward
the center of the vehicle to
remove from the plastic
wire harness protector.
GE07 Factory Ground Location
Wire Tie
Antenna Cable
Revision Date
M8 Bolt
Middle Hole Not Used
Wire Tie
5/2/2012
After Relocation
MDPS Control Module
Large Wire Tie
Relay Location
Steering Column
Dash Wall
Grommet
Page 9 of 29
3
4
Advertisement
