Advertisement
Remote Start Harness
Male 24-Pin Connector
Factory Male I/P-C
Connector
HYUNDAI Genuine Accessories (Installation)
Remote Start Harness Male
Brake Switch Connector
Remote Start Harness
Female 24-Pin Connector
Revision Date
Remote Start Harness
Female Brake Switch
Connector
Wire Tie
Factory Male
E18 Connector
Wire Cutter
*Route the remote start harness 4-pin male and
N
female connectors to the factory E18 brake switch
O
connector.
T
E
*Disconnect the factory male 4-pin E18 brake switch
connector and plug in the corresponding remote
start harness connectors.
*Secure the factory male 4-pin E18 connector and the
remote start harness female connector to the vehicle
wire harness with (1) small wire tie, as shown above.
Trim off excess wire tie.
CAUTION! Ensure there is adequate clearance
between the remote start harness and the tilt
steering wheel vertical bracket to avoid a short
circuit / blown fuse.
*Route the remote start harness 24-pin male
N
and female connectors to the front of the
O
fuse panel.
T
*Disconnect the factory male I/P-C connector
E
and plug in the corresponding remote start
harness connectors.
5/2/2012
7
8
Page 11 of 29
Advertisement
