Advertisement
** Unplug connector, if necessary, to
identify proper pin location
1
2
5
6
8
9
10
11
TERMINAL END VIEW
EM11 Connector
Tachometer Wire
Blue Wire
Pin 25
Pliers, Wire Cutter
*Refer to Page 3 for T-Tap Installation Procedure.
N
*Route the remote start harness Blue (Tachometer Input), Yellow (Dome Light Output) and the Black with ring terminal (Ground)
O
wires to the driver's kick panel area.
T
*Using pliers, crimp a T-Tap on the Blue wire located in pin #25 of the 55-pin EM11 male connector, located in the driver's kick panel
E
area.
*Connect the Blue (Tachometer Input) wire from the remote start harness to the Blue wire (Pin #25 of the EM11 connector) by
engaging the T-Tap.
*Secure the Blue (Tachometer Input), Yellow (Dome Light Output) and the Black with ring terminal (Ground) wires to the vehicle
wire harness with (1) small wire tie, as shown above. Trim off excess wire tie.
CAUTION! Ensure the correct pin location is identified. There may be several wires of the same/similar color.
HYUNDAI Genuine Accessories (Installation)
16
31
17
42
18
27
52
44
19
28
35
45
21
29
54
38
48
24
49
25
26
51
Wire Tie
Revision Date
5/2/2012
12
Page 15 of 29
Advertisement
