Sames Inocart VT Instruction Manual page 32

• Step 7: Position / center the inner tube on the center
guide of the tool.
• Step 8: By pressing firmly on the top of the tube (can
be tapped with the mallet) push the center tube into
the washer until the outer tube starts to center on the
nose.
• Step 9: Once the nose is centered in the tube, by
tapping vertically with the mallet at the top of the
tube on the aluminum body, push the nose into the
outer tube:
The nose is resting on the outer tube.
The aluminium body is in contact with the outer tube.
• Step 10: Check the position of the holes in the inner
tube.
Member of Exel group 32
+/-15
DRT7159
B - 2023/03