Sames Inocart VT Instruction Manual page 26

• Step 5: Place the fluidizing tube over the Fast Clean
and press 2 or 3 times to clean the internal circuit.
Never use the Fast Clean if the cleaning mode is not
activated.
• Step 6: Disconnect the CS 130 pump from the
fluidizing tube and place it on its holder. Cleaning
cycles continue to run to rinse the pump and tubing.
• Step 7: Blow the outside of the tube into the booth.
• Step 8: Put the CS 130 pump back on the fluidizing
tube, put the fluidizing tube back on the arm and dip
the tube into the new powder box.
Do not disconnect the power supply and pump connections when the cleaning mode is
activated.
Member of Exel group 26
DRT7159
B - 2023/03