Table of Contents
Advertisement
8.4.4. Procedure C4: Fast Clean replacement
• Step 1: Disconnect the hose from the Fast Clean.
• Step 2: Unscrew the 2 screws (A) securing the Fast
Clean and remove it.
• Step 3: Insert the new Fast Clean, tighten the 2
screws (A) and then reconnect it.
8.4.5. Procedure C5: Replacement of the equipped porous washer
Disassembly:
• Step 1: Using soft rubber clamps, textile protection or thick cardboard, clamp the aluminium body of the tube
in a vice and unscrew the outer tube manually.
The inner tube remains attached to the body.
• Step 2: Using a 20 to 30 mm diameter bar of sufficient length (broomstick style), remove the black nose from
the outer tube:
Tube laid flat on a work surface, passing through the inside of the tube, hit the nose with the rod.
Repeat if necessary.
Reassemble the equipped porous washer:
• Step 3: Put the inner tube and the aluminium body back into the outer tube.
• Step 4: Using a mallet, insert the aluminium body into the outer tube. Leave a gap of +/-0.5 mm between the
shoulder of the body and the tube.
• Step 5: Place the nose assembly tool (P/N: 900020525) on the work surface or on the floor.
• Step 6: Place the new nose on the tool with the porous washer down.
Member of Exel group
31
A
DRT7159
B - 2023/03
Advertisement
Table of Contents
