Sames Inocart VT Instruction Manual page 29

Reassembly
• Step 7: Apply a few drops of normal threadlocker
(P/N H2CPAL046) on the 4 fixing screws
• Step 8: Place the vibrator on the cart, screw the
screws crosswise and in approach, then tighten to a
torque of 10 N.m.
• Step 9: Attach the ground cable lug by tightening the
screw to a torque of 7 N.m.
• Step 10: Replace the vibrator panel.
• Step 11: Replace the vibrating table by checking the
condition of the elastic pads, replace them if
necessary.
• Step 12: Tighten the 4 screws fixing the vibrator
panel.
• Step 13: Reconnect the vibrator cable on the Inobox
side.
Member of Exel group 29
DRT7159
B - 2023/03