Use Of Inocart Vt Or H Equipment; Powder Application - Sames Inocart VT Instruction Manual

7. Use of Inocart VT or H equipment

7.1. Powder application

As the equipment has already been installed according to the safety rules
given (see § 6 page 18), follow the steps described below:
• Step 1: Connect the ground cable of the cart to a conductive and earthed part of the spray booth; the ground
potential must be identical to that of the part to be powdered.
• Step 2: Electrically and pneumatically power the equipment.
• Step 3: Position the open powder box on the vibrating table or put powder in the hopper.
• Step 4: Switch on the Inobox control module
• Step 5: (see DRT7132
Inobox module. It is possible to adjust the powder flow rate directly on the gun.
• Step 6: Point the gun nozzle towards the booth and the part to be powdered and press the trigger.
• Step 7: For the vibrating table version, close the plastic bag containing the powder around the plunger tube
(see § 1 page 6).
Member of Exel group
(see
or see DRT7145) to adjust the application settings for the parts to be powdered on the
(see § 1.5 page
DRT7145) (ON button on the front of the module).
22
9) and the instructions
DRT7159
B - 2023/03