Procedure C2: Replacement Of Vibrator - Sames Inocart VT Instruction Manual

8.4.2. Procedure C2: Replacement of vibrator

Removal
• Step 1: Disconnect the vibrator cable on the Inobox
side.
• Step 2: Remove the vibrating table
(see § 8.4.3 page 30).
• Step 3: Remove the vibrator wall by unscrewing the 4
screws/washers.
• Step 4: Disconnect the ground wire (B) from the
vibrator.
• Step 5: Unscrew the 4 vibrator fastening screws (A).
• Step 6: Disconnect the vibrator.
Member of Exel group
A
28
B
DRT7159
B - 2023/03