Table of Contents
Advertisement
1.7. Important recommendations
1.7.1. Ventilation
Do not start the powder application with the Inogun M spray gun until the spray booth ventilation system is
switched on. If the ventilation is switched off, toxic substances or dust may remain in the spray booth and cause a
risk of fire, poisoning or irritation.
1.7.2. Valve protection for Inobox or Inocontroller control modules
• When using the Fast Clean on the Inocart cart, the control module must be set to cleaning mode to
prevent powder from rising in the control module valves.
• When cleaning the CS 130 powder pump with compressed air, both the injection and dilution quick
connectors must be disconnected to avoid powder backflow.
• With the Inocenter, the injection and dilution controls are activated during the cleaning process.
• When using venturi pumps without a check valve, it is important to ensure that both airs are activated
simultaneously to avoid powder backflow into the valves of the control module.
1.7.3. O-ring seals
Use the seals recommended in this manual.
1.7.4. Ambient temperature
The equipment is designed to normally operate at an ambient temperature comprised between 0°C and + 40°C
(32 °F to 104 °F)
The storage temperature must never exceed +60°C.
1.7.5. Sound level
The sound pressure level generated by Inocart VT is equal to 80.2 dBA and 78.1 dBA for the Inocart H under
the specified operating conditions.
Conditions of measurement:
The equipment was put into operation at maximum characteristics, the measurements were carried out at different
positions at 1 m from the cart without powder in the Powder laboratory at the Sames site in Meylan, France.
Method of measurement:
The accoustic pressure level, continuous, equivalent, weighted (80.2 dBA or 78.1 according to the version of the cart)
is given in LEQ value, measured for observation periods of at least 30 seconds.
Member of Exel group
12
DRT7159
B - 2023/03
Advertisement
Table of Contents
