Hopper Version - Sames Inocart VT Instruction Manual

6.2. Hopper version

• Step 1: Release the ground wire lug attached to the
cart and connect it to the hopper.
Then connect the fluidizing hose to the hopper.
• Step 2: Equip the plunger tube with the CS 130 pump,
then place the assembly in one of the holes in the
hopper. Connect the 2 hoses on the powder pump
blue to blue, red to red.
• Step 3: Connect the 5 m ground cable to an
electrically grounded part of the powdering booth.
• Step 4: Connect the Inobox power supply.
• Step 5: Connect the powder supply hose from the
gun to the CS 130 pump and connect the electrode
blowing hose on the Inobox controll module side and
on the gun side.
• Step 6: Connect the plastic fume exhaust hose to the
tank on one side and to the booth on the other.
Note: the connection point on the booth must
always be positioned above the hopper to
prevent the plastic sheath from "sinking" and to
limit the clogging of the sheath.
Regularly check the inside of the sheath to
prevent clogging.
The Inocart H cart is ready to start the powder application.
Member of Exel group 20
DRT7159
B - 2023/03