Table of Contents
Advertisement
KTD-N0876-0
2
Installation Procedure
2.1 Installing the Board
To get the board running, follow these steps. If the board shipped
from KONTRON has already components like RAM mounted, then relevant
steps below can be skipped.
1. Turn off the PSU (Power Supply Unit)
Warning: Turn off PSU (Power Supply Unit) befor configuring
!
the board and do not hot plug power supply, otherwise
components (RAM, LAN cards etc.) might get damaged.
2. Insert the DDR3 UDIMM 240 Pin module(s)
Be careful to push it in the slot(s) before locking the tabs.
3. Connecting Interfaces and PSU
Insert
all
external
display/monitor must be connected in order to be able to change
BIOS settings. Connect a standard ATX/BTX PSU to the board by the
inserting power cables into 24-pin ATX and the 4-pin ATX+12V PWR
plugs connectors.
4. Power Button
Turn
on
mains
PWRBTN_IN
must
(PWRBTN_IN)
and
Connector description), by use of a "normally open" switch etc.
5. BIOS Setup
Enter the BIOS setup by pressing the <Del> key during boot up. Enter
Exit
Menu
and
Configuration / Setup" section of this manual for details on BIOS
setup.
Note: To clear all BIOS settings, including Password protection,
activate Clear CMOS Jumper for ~10 sec (without power connected).
6. Mounting the board to chassis
It is recommended using screws with integrated washer and having
diameter of approx. 7mm.
Warning: please notice that the board contains components on
both sides of the PCB which can easily be damaged if board is
!
handled without reasonable care. A damaged component can
result in malfunction or no function at all. Do not use
washers with teeth as they can damage the PCB and may cause
Page 6
cables
for
power
to
the
PSU.
be
toggled;
this
pin
18
(GND)
Load
Optimal
KTA75/Flex Users Guide
KTA75/Flex Users Guide
System Specifications
hard
disk,
keyboard
If
board
doesn't
is
done
by
shorting
on
the
FRONTPNL
Defaults.
Refer
etc.
A
boot,
then
pins
16
connector
(see
to
the
"BIOS
Advertisement
Table of Contents
