Table of Contents
Advertisement
KTD-N0876-0
Signal
Description
5V supply for external devices.
during
USB0_5V/USB1_5V
activity.
fuse.
Universal
USB0+/USB0-
Data/Address/Command Bus.
Universal
USB1+/USB1-
Data/Address/Command Bus.
Maximum load is 1A if using IDC connector or 2A if
+5V
using crimp terminals .
SATA Activity LED (active low signal). 3V3 output
SATA_LED#
when passive.
Suspend Mode LED (active high signal). Output 3.3V
SUS_LED
via 470Ω.
Power Button In. Toggle this signal low to start the
PWRBTN_IN#
ATX / BTX PSU and boot the board.
Reset Input. When pulled low for a minimum 16ms, the
RSTIN#
reset process will be initiated. The reset process
continues even though the Reset Input is kept low.
Line2 is second stereo Line signals
LINE2
MIC2
MIC2 is second stereo microphone input.
SB3V3
Standby 3.3V voltage
AGND
Analogue Ground for Audio
Note: In order to meet the requirements of USB standard, the 5V input
supply must be at least 5.00V.
Available cable kit:
PN 821042 Cable Front Panel Open-End, 300 mm
Page 39
powerdown
to
allow
Protected
by
Serial
Bus
Serial
Bus
KTA75/Flex Users Guide
KTA75/Flex Users Guide
Connector Signal Definition
SB5V is supplied
wakeup
on
independed
resettable
Port
0
Differentials:
Port
1
Differentials:
USB
device
1.1A
Bus
Bus
Advertisement
Table of Contents
