Introduction - Kontron KTA75/Flex User Manual

KTD-N0876-0
1

Introduction

This manual describes the KTA75/Flex family of boards made by KONTRON
Technology A/S. These board will also be denoted KTA75 within this
Users Guide.
The KTA75 is designed to support the listed APU variants (uPGA 722pin
processors) and AMD A75 Fusion Controller Hub (FCH) A75 on a Flex form
factor. See the chapter System Specifications for more specific
details.
APU variants
R-464L
R-460H
R-272F
R-268D
The 4 versions have the same type of active CPU cooler (the cooler is
by default not premounted, but can be ordered with this obtion).
Use of this Users Guide implies a basic knowledge of PC-AT hard- and
software. This manual is focused on describing the KTA75 board's
special features and is not intended to be a standard PC-AT textbook.
New users are recommended to study the Installation Procedure stated
in the following chapter before switching-on the power.
All configuration
automatically or manually by the user via the BIOS setup menus. Only
exceptions are the Clear CMOS jumper and the Always On jumper.
Page 5
AMD PN
RE464LDEC44HJE
RE460HDEC44HJE
RE272FDEC23HJE
RE268DDEC23HJE
and setup of the
KTA75/Flex Users Guide
KTA75/Flex Users Guide
Introduction
Processor data
2.3 GHz – Quad Core – 35W
1.9 GHz – Quad Core – 35W
2.7 GHz – Dual Core – 35W
2.5 GHz – Dual Core – 35W
CPU board is either done