Table of Contents
Advertisement
KTD-N0876-0
The 3 DisplayPorts (DP0, DP1 and DP2) can be used in 3 independt
display configurations. By use of DP Adapter Converters it is possible
to implement a mix of DP, VGA, HDMI and DVI-D outputs and still
support 3 independt display configuration.
Available DP adapters:
DP to VGA
PN 1045-5779
DP Extention Cable:
In order to prevent mechanical conflicts the above DP adapters can be
connected to DP#0, DP#1 and DP#2 via the 1051-7619 Cable DP Extender
cable 200mm.
The DP to VGA adapter is an "active" converter, meaning that seen from
the
graphics
controller
converters
are
passive
graphics controller about its type and the graphics controller then
replace the DP signals with TMDS signals (used in HDMI and DVI).
The HDMI interface supports the HDMI 1.4a specification including
audio codec. Limitations to the resolution apply: 2048x1536 (VGA),
1920x1200 (HDMI and DVI).
4 independt (simultaneously) displays (without using PCIe Graphics
cards) is a possible configuration under the following conditions:
1. A PCIe-DP passive card must be used in the outermost PCIe slot.
2. All DP must be converted to DP-DVI-D or DP-HDMI via passive
adapters like above adapters. (Restriction, only one adapter can
be HDMI type)
3. Two of the panels must have the same timing (meaning two display
monitors have to be exact same type).
Page 22
DP to HDMI
PN 1045-5781
it
looks
like
converters,
meaning
KTA75/Flex Users Guide
KTA75/Flex Users Guide
Connector Signal Definition
DP to DVI-D
PN 1045-5780
a
DP.
The
HDMI
that
they
and
DVI
inform
the
Advertisement
Table of Contents
