Usb4/5 Connector (J16) - Kontron KTA75/Flex User Manual

KTD-N0876-0

7.4 USB4/5 Connector (J16)

USB Ports 4 and 5 are available via Pin Row connector type Foxconn
HS1105F-RNP9 or similar.
The USB4 port is controlled by a set of OHCI and EHCI controllers
(also shared by USB0/1/2).
The USB5 port is controlled by a set of OHCI and EHCI controllers
(also shared by USB6/7/8/9).
The OHCI controllers support USB1.1, Full-Speed (12Mbps) and Low-Speed
(1.5Mbps).
The EHCI controllers support USB2.0, High-Speed (480Mbps).
Signa
Header Pin
5V/SB
1
5V
5V/SB
2
5V
3 USB4-
4 USB5-
5 USB4+
6 USB4+
7 GND
8 GND
-
10 KEY
Notes: In order to meet the requirements of USB standard, the 5V input supply
must be at least 5.00V.
The contacts for USB devices are protected and suitable to supply USB devices
with a maximum input current of 1000mA.
Do not supply external USB devices with higher power dissipation through these
pinsTo protect the external power lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available
current.
- to enclosure of the peripheral device fulfills the fire-protecting
conditions of IEC/EN 60950.
Page 32
l
5V (always) protected by separate 1A
5V (always) protected by separate 1A
Differential pair 4 -
Differential pair 5 -
Differential pair 4 +
Differential pair 5 +
(pin not mounted -Used for keying)
KTA75/Flex Users Guide
KTA75/Flex Users Guide
Connector Signal Definition
Description
resettable fuse
resettable fuse
Ground
Ground
Type
PWR
PWR
DSIO-
3.3
DSIO-
3.3
DSIO-
3.3
DSIO-
3.3
PWR
PWR
NC