Art Wireless Transceivers ('Dongles') Settings - Art DTRACK3 User Manual

8 Menu Hardware - Hardware configuration
Info
Device ID dongle
Model
Firmware Version
Currently used
channel
Table 8.11: ART wireless transceivers ('Dongles') settings (only available settings are
listed)
At this point only dongles should be listed, otherwise check that all previously added sen-
sors show up together with their corresponding dongle. Please refer to figure 8.10 on
page 87.
Next scan the available radio channels by pressing
pletion the drop-down menu in the column
for each dongle (see figure 8.8 on page 84). The currently used channel is marked in bold
digits. All channels that are not recommended are greyed out (occupied by other Wi-Fi
devices in range), while all recommended channels are marked green.
Please select an appropriate channel for each dongle now. The selected dongle will
change its channel accordingly and likewise all assigned sensors.
Figure 8.8: Dongle Configuration - Selection of a radio channel
The default channels for all dongles and sensors are 35 and 55 (out of
80).
Do not set both dongles to the same channel or on occupied frequen-
cies from other devices in range..
In case channels are already occupied by other devices in range (e.g.
WLAN) connection problems may occur.
for available channels and to select free channels accordingly. A mini-
mum distance of 10 channels is mandatory between dongles and rec-
ommended from occupied channels for optimum connectivity.
84
Description
Shows the serial number of the transceiver
Shows the type of the transceiver (Dongle USB only)
Shows the firmware version of the transceiver
radio Shows the radio channel of the transceiver (default: 35 / 55);
use the drop-down menu to change the radio channel
Channel
Scan available channels. After com-
will show a list of all available channels
ART recommends to scan