Art DTRACK3 User Manual page 182

13 Frequently asked questions (FAQ)
My Flystick2/2+/3
Make sure that the battery is charged. Press any button of the
the orange status LED should be switched on.
Go to Hardware
recognized.
Go to Hardware
manually.
Why is the pressing of the
DTRACK3 )?
Make sure that the battery is charged. Press any button of the
the orange status LED should be switched on.
Double-check whether the button pressed events are recognized by
Therefore:
– enable the Flystick Display
– blue rectangles should light up on each button pressed event in the Flystick
Display.
Go to Hardware
recognized.
Go to Hardware
manually.
Go to Tracking
Flysticks list) to any
Why is the pressing of the
graphics application)?
Make sure that the battery is charged. Press any button of the
the orange status LED should be switched on.
Go to Tracking
Flysticks list) to any
Go to Tracking
– data receiver defined
– identifier '6df2' selected,
– if you are using the legacy
182
is not listed under the available Flysticks list.
ART Radio Info
ART Radio Info
Flystick2/2+/3
(View
ART Radio Info
ART Radio Info
Flystick and assign your Flystick (to be found in the available
'Flystick ID'.
Flystick2/2+/3
Flystick and assign your Flystick (to be found in the available
'Flystick ID'.
Output and check if the data output is configured correctly:
('send to'),
old output
ART
to see if the radio transceiver has been
Show details and set the channel number
buttons not recognized (within
Flystick )
ART
to see if the radio transceiver has been
Show details and set the channel number
buttons not recognized (within the
format: identifier
Flystick2/2+/3
Flystick2/2+/3
DTRACK3
Flystick2/2+/3
'6df ' selected.
and
and
.
and