Art DTRACK3 User Manual page 72

8 Menu Hardware - Hardware configuration
Column
Camera
Model
Serial
Flash intensity
Modulated flash
Static reflex suppr.
Sync group
Camera mode
Room cal
0 .. 8 for ARTTRACK2
0 .. 100 for ARTTRACK6/M
SMARTTRACK3
0 .. 7 for TRACKPACK
ARTTRACK6/M for Active Markers
0 only for
The flash setting strongly depends on the working area and range. In-
crease the flash intensity until all markers become yellow or green us-
ing the
sity bar on the top right corner of each camera monitor. Please refer to
chapter 6.3.1 on page 45 for instructions.
As a rule of thumb: For measurement applications with high accuracy
requirements the markers should be displayed in green with intensities
of min. 4 bars; for VR applications yellow markers with intensities
down to 2 bars are still sufficient.
When using
the modulated flash and the sync group is changed simultaneously for
both cameras.
The ARTTRACK6/M for Active Markers
flash. Thus it is not possible to adjust the flash intensity.
When using
the flash intensity of the corresponding external flashes with the
DTRACK3
Please contact
the external flashes.
72
Description
Shows the assigned camera ID c01 to ... (compare 2-digit
LED matrix display on
Shows the type of camera
Shows ART
SMARTTRACK3
R for
eras)
Change the currently set flash intensity (individually)
(De-)activates the synchronisation signal and trigger for active
targets (individually)
(De-)activates the static reflex suppression for this camera (in-
dividually)
Select the syncgroup
TRACK6/M
PACK/E individually)
Select the camera mode (available modes depend on model,
set individually)
Shows the status of room calibration (i.e. 'no' for newly added
but not yet calibrated cameras)
Table 8.2: Menu
/ ARTTRACK3
, ARTTRACK5
& SMARTTRACK3/M
(discontinued).
Monitor 2DOF display. Additionally pay attention to the inten-
SMARTTRACK3
ARTTRACK2/C
frontend software!
ART in case you need to adjust the flash intensity of
ARTTRACK5
internal serial number of each camera (suffix L /
SMARTTRACK3/M
&
('Channel 1' -
, ARTTRACK5 , ARTTRACK5/C
Camera Settings
(discontinued),
, ARTTRACK5/C
& SMARTTRACK3/M
cameras do not offer an infrared
cameras it is not possible to adjust
)
left & right cam-
'Channel 3' for ART-
& TRACK-
, TRACKPACK/E
the flash intensity,
and