Art DTRACK3 User Manual page 74

8 Menu Hardware - Hardware configuration
higher max. frame-rates (refer to
Specifications
lower latencies (i.e. time delays for measurement data).
To switch the camera mode, click on the field in the column
drop-down menu (e.g.
The max. frame-rate is limited by the camera with the largest field of
view selected respectively the max. frame-rate of that individual cam-
era. In mixed systems the max. frame-rate is always limited to 60
Hz (ARTTRACK2
TRACKPACK/E
TRACK5
Note: Higher frame-rates come at the cost of the cameras' reduced
field of view.
Room cal This indicator shows whether the corresponding camera was present and
running during the last valid room calibration. Hence,
used for measurements and will contribute to the tracking. On the contrary
that additional cameras have been added to an existing configuration without performing
a room (re-)calibration. Thus a (re-)calibration is necessary for the corresponding camera
to contribute to the tracking. Please refer to chapter 8.1 on page 68 on how to add new
cameras dynamically.
The ART Controller
have been removed from an already calibrated tracking system (e.g.
due to a disconnected cable) and mark those as missing until a room
(re-)calibration has been performed. The corresponding entries are
greyed out to show that the cameras have been disabled. The only
data shown is model and serial number.
DTRACK3
moved; for best performance it is highly recommended to perform a
re-calibration.
Global settings Tick the checkboxes to adjust the corresponding settings for all cam-
eras at once.
global flash intensity
Move the adjacent slider to adjust the flash intensities of all cameras globally.
static reflex suppression
Tick the corresponding checkbox to activate the support of static reflex suppression
for all cameras at once.
global camera mode
Set the field of view for all cameras globally by using the adjacent dropdown-menu
(e.g. 1.1 Mpix, max. 60
74
for each camera model)
1.1 Mpix, max. 60
or ARTTRACK3
) or 120 Hz
) respectively.
or ART Controller/M
is able to operate when cameras have been added or re-
Hz) on the right.
ART Hardware Installation Guide
Hz).
with ARTTRACK6/M
(TRACKPACK/E with
yes shows that the camera will be
will detect all cameras that
Technical
'Camera mode' to open a
, ARTTRACK5
ARTTRACK6/M or
no indicates
or
ART-