Art DTRACK3 User Manual page 34

5 Connecting to the controller
You can easily identify your controller by comparing the serial number (e.g.
troller
301422021 or
sponding one printed on the label of the device (rear of the
troller/M and SMARTTRACK3
Installation Guide
Select the appropriate entry of your controller and press Connect.
If nothing is listed, please refer to chapter 13 on page 169.
If the Controller is not connected to a LAN or no DHCP server is run-
ning, it will use its fall-back IP address (IP 192.168.0.1, subnet mask
255.255.255.0)
If the access to the controller has been restricted, you will be prompted
to enter the password before the main window will open. In case you
have lost the password, please refer to chapter 5.3.1 on page 38 to
reset the password feature.
34
(a) specific controller
(b) scan the network
Figure 5.2: Controller Selection
SMARTTRACK3
& SMARTTRACK3/M
). You can also sort the list by host-name
s3-00432 listed in column Serial) with the corre-
, please refer to
ART Con-
ART Controller or ART Con-
ART Hardware
Name or IP-addresses IP.