Measurement Tool; Active Targets; Art Tracking And 3D Tvs - Art DTRACK3 User Manual

The Fingertracking
Go to Tracking Output
data receiver defined
identifiers 'gl' and 'glcal' selected.
Is it possible to upgrade to the 3-finger or the 5-finger version?
Yes, if you are currently using the non-tactile 3-finger version you may also use 5-finger
thimble sets and vice versa. Tactile thimbles are available for 3 fingers only. Please
contact ART to receive more information.

13.11 Measurement Tool

I'm using the Measure Points
Please check whether both, the Measurement Tool and the Measurement Tool reference
body (if assigned), are tracked.
It is not possible to perform a tip calibration.
Please check whether both, the Measurement Tool and the Measurement Tool reference
body (if assigned), are tracked.
Then, try to keep the tip in the same position while doing the tip calibration. Therefore, tilt
the Measurement Tool in both room directions, not only in one direction (i.e. left and right,
as well as back and forth). When rotating around one axis only, a tip position cannot be
defined.

13.12 Active Targets

Operation near plasma screen
A plasma screen is a very strong IR source which overdrives the IR receiver in the active
target (e.g. active Flystick3
not work properly near plasma screens. If possible use passive targets as alternative.
13.13 ART tracking and 3D TVs
Synchronization
3D TVs are primarily consumer products which have not been designed to fulfill the re-
quirements of professional users. In fact, this especially applies when it comes to synchro-
nizing the 3D TV and the tracking system. Typically, there's no defined synchronization
output which could be used easily. In some rare cases,
output data is not transmitted.
and check if the data output is configured correctly:
('send to'),
tool but I cannot measure any points.
(discontinued),
13.11 Measurement Tool
Fingertracking ). Thus, active targets may
ART might be able to assist.
185