Art DTRACK3 User Manual page 73

Keep a distance of min. 20 cm when operating the cameras ! All cam-
eras are assigned to the Exempt Group according to IEC62471-1 and
therefore pose no risk or hazard to the human eye or skin at this dis-
tance.
Modulated flash ART
consisting of infrared LEDs instead of retro reflective material (please refer to the
Hardware Installation Guide
in the table to activate the synchronisation signal (i.e. coded IR flash) that triggers active
targets for individual cameras.
The effective flash intensity is reduced significantly when the modula-
tion is used in combination with low flash intensities. The influence is
negligible at higher flash intensity settings. Simply increase the flash
intensity, if necessary.
The range of the modulated flash is significantly higher than the effec-
tive tracking distance of the cameras.
All cameras with activated modulated flash have to be assigned to
syncgroup #1 (default for
TRACK6/M
PACK systems may be configured via software.
TRACK3
'OUT ' on the
Static reflex suppr. Tick the corresponding checkbox to activate the support of static
reflex suppression. Please refer to the 6.3.2 on page 49 for further information.
Sync group In case of mutual blinding of cameras (see
Guide Setting up the
adjacent cameras. You may change the assignment either on the
the Individual tab of the respective camera. Click on the appropriate field in the column
'Sync group' to open a drop-down menu. Possible values are
'Channel 3'.
These channels correspond to the three syncgroup outputs (time delays #1: 0 s, #2: 480
s, #3: 960 s on the
time delays please refer to 8.4 on page 78.
Please refer to the ART Hardware Installation Guide
syncgroup assignment of
The ART Controller/M
ARTTRACK3
Camera mode Depending on the model and on your application you can change the
camera mode (i.e. the field of view) in order to achieve:
tracking systems can be used with active markers, i.e. markers
Markers &
SMARTTRACK3
, ARTTRACK5 , ARTTRACK5/C
have to be connected to 'OUT1' on the
ART Controller/M
cameras) one can assign different syncgroups for opposing or
ART Controller or ART Controller/M
ARTTRACK cameras in backward compatible systems.
offers synchronization output for
cameras on syncgroup #1 only !
Targets). Tick the checkbox
& SMARTTRACK3/M
, TRACKPACK/E
ARTTRACK2
respectively.
ART Hardware Installation
'Channel
). To change the predefined
Installation of the Controller
8.3 Camera Settings
ART
modulated flash
) ! ART-
, & TRACK-
& ART-
ART Controller and
All Cameras tab or on
1', 'Channel 2' or
for
ARTTRACK1 –
73