Art DTRACK3 User Manual page 184

13 Frequently asked questions (FAQ)
When using Fingertracking, there are always some markers that are flashing
alternately in the Monitor 2DOF display.
This is not bug, but rather it is due to the sequential activation of the finger thimble markers
in order to achieve a separation of the fingers.
What's the meaning of the status LEDs on the Fingertracking hand target?
Please refer to the
devices for more information.
What is being configured when turning the configuration dial?
Please refer to the
devices for more information.
What's the maximum number of hands to be used?
You may use two Fingertracking
same time. However, the targets of the hand devices must be different.
How do I assign a hand geometry to a hand ID?
Go to Tracking
details.
The finger calibration fails. What do I do wrong?
The configuration dial has to be turned to the proper position. Please refer to the
ART Hardware Installation Guide
information.
Go to Hardware
select the ones that have unobstructed view of the whole tracking area. Furthermore
all cameras with activated
ARTTRACK5
configured via software, while
to 'OUT1' on the controller's
Please observe the calibration procedure defined in chapter 9.8.4 on page 143.
Make sure that you selected the correct handedness and type of fingerset in
ing Fingertracking
Double-check that the diffusor spheres (not applicable for
are not broken or missing.
184
ART Hardware Installation Guide
ART Hardware Installation Guide
sets (i.e. four hands) in your tracking system at the
Fingertracking. Please refer to chapter 9.8 on page 137 for further
Cameras and tick the checkbox
modulated flash
, ARTTRACK5/C ,
ARTTRACK2
Synccard2/3
Hand geometry
System setup
have to be assigned to syncgroup #1 !
TRACKPACK/E , &
& ARTTRACK3
.
calibration.
System setup
System setup
Interaction devices
'modulated flash'. Alternatively
TRACKPACK systems may be
have to be connected
FINGERTRACKING2
Interaction
Interaction
for more
Track-
)