Art DTRACK3 User Manual page 163

Click Next to start the update process. Confirm by clicking
(see figure 12.3(a) on page 163). A final warning will open after which the update is
started (see figure 12.3(b) on page 163). Do not stop the process afterwards.
(a) Confirmation window
The update assistant will then show the current status using a progress bar (refer to
12.4(a) page 163). Depending on the update this may take several minutes.
(a) Update Assistant progress bar
After the update has been completed the controller has to be restarted to finalize the up-
date process. In order to restart directly click
page 163).
You may also continue with your measurement by clicking No. The update assistant will
show that your controller is up-to-date (refer to 12.5 on page 164). Click
the update assistant. Please remember to restart the controller later on.
Personal settings and configurations (e.g. room and body calibration,
output settings, etc.) will be preserved during update!
Updates of the camera firmware are installed in a seperate run after the
controller has been updated completely.
Figure 12.3: Confirming the update
Figure 12.4: Running the update
Yes
12.3 Controller Update
Yes in the upcoming dialog
(b) Confirmation warning
(b) Restart warning
in the upcoming dialog (refer to 12.4(b)
Finish to close
163