Inertial Sensor Settings - Connecting Wireless Transceivers - Art ARTTRACK1 System User Manual

Figure 7.1: Inertial Sensor Settings - Connecting wireless transceivers
Temperature (n/a)
Frequency (n/a)
Calibration Status (n/a)
Delete function (n/a)
At this point only dongles should be listed, otherwise check that all previously added sen-
sors show up together with their corresponding dongle. Please refer to figure 7.4 on page
110.
Next scan the available radio channels by pressing
pletion the drop-down menu in the column
nels for each dongle (see figure 7.2 on page 107). The currently used channel is marked
in bold digits, while all channels that are not recommended are greyed out. Additionally
DTrack2 shows recommended channels (marked green).
Figure 7.2: Dongle Configuration - Selection of a radio channel
7.1 Hybrid motion capture suit
Scan available
Channel will show a list of all available chan-
channels. After com-
107