supported Synccard modes
internal generated signal, ... Hz
external video signal
external video signal, for validated shutter glasses
external video signal, for validated shutter glasses, divisor 2
external TTL signal
external TTL signal, for validated shutter glasses
external TTL signal, for validated shutter glasses, divisor 2
external TTL signal both edges
external TTL signal both edges, for validated shutter glasses
direct settings
1
predefined settings that should be used with the shutter glasses listed in table 8.8 on page 80
2
use this mode if the frequency of the external synchronisation signal is 2x higher than the max. frame-
rate of the camera or
SMARTTRACK2
3
available only for
Synccard2/3
TRACK2
)
Table 8.7: Overview of the supported synccard modes
The TTL input signal level should be 5 Volt (TTL) and 3 Volt (LVTTL)
respectively with a minimum change of 2.5 Volt and duty cycle between
10% and 70 % regardless of input frequency.
Figure 8.5: Synccard Settings
1
1
3
(not available for
and
SMARTTRACK3
&
8.4 Synccard Settings
field of application
run the controller without exter-
nal synchronisation (available val-
ues dependent on camera model)
active-stereo projection with an
analogue video sync signal (=VGA)
12
active-stereo projection with a TTL
sync signal, triggers on rising edge
12
see above, triggers on rising AND
13
falling edge
advanced custom settings
SMARTTRACK3
&
SMARTTRACK3/M
SMARTTRACK3/M
(not available for
)
SMART-
79