Art DTRACK3 User Manual page 37

5.3 Configuring your controller's network address without network access
Proceed as follows:
Plug-in the USB pen drive in any available USB port of the controller. Controller can
be powered up or off
If necessary start up the controller
Wait some time for the controller to write two files onto the USB pen drive (approx.
20-30 seconds, signalled by two (2) consecutive beeps)
Unplug the USB pen drive
Now plug-in the USB pen drive in a computer and view or edit the setup file (see 5.3
on page 37) with any editor
After changing the setup file please plug-in the USB pen drive in the controller again
afterwards
Wait some time for the controller to read the setup file (approx. 20-30 seconds,
signalled by three (3) consecutive beeps)
Unplug the USB pen drive
Reboot the controller for the changes to take effect
Now, your controller is configured according to your requirements.
Please note that these settings are not part of your personal configu-
ration. Changes will affect all users of your controller! Your controller
may become unreachable with wrong IP settings!
You can
'ART_Controller_XXXX_licenses.txt' (will be written to USB pen
drive during factory reset)
The setup file Following, a description of the file (e.g. ART_Controller_00117_setup.txt)
format:
# ART Controller Setup:
# ethernet settings:
# - uncomment just one of the lines starting with 'SETNET'
# ethernet settings: DHCP
# - uncomment the following line to activate DHCP
#SETNET="dhcp"
# ethernet settings: fix IP address and subnet mask
# - uncomment the following line to set a fix IP address and subnet mask
#SETNET="ip 192.168.0.1 255.255.255.0"
# ethernet and routing settings: fix IP address, subnet mask and corresponding gateway
find your current license codes in the file
37