Commissioning; Commissioning Procedure; Gas Settings; Adjusting To A Different Gas Type - REMEHA Quinta Ace 30 Installation And User Manual

7 Commissioning

7 Commissioning
7.1

Commissioning procedure

7.2

Gas settings

Fig.35 Position of adjusting screw A
A
Tab.27 Factory settings G20 (H-gas)
Code Display text
DP003 Abs. max fan
DHW
GP007 Fan RPM Max
CH
GP008 Fan RPM Min
GP009 Fan RPM Start
36
1 2
A
AD-0000067-02
Description
Maximum fan speed on
Domestic Hot Water
Maximum fan speed
during Central Heating
mode
Minimum fan speed
during Central Heating +
Domestic Hot Water
mode
Fan speed at appliance
start
Warning
Initial commissioning must be done by a qualified installer.
If adapting to another type of gas, e.g. propane, the boiler must
be adjusted before it is switched it on.
See
Adjusting to a different gas type, page 36
1. Open the main gas tap.
2. Open the boiler gas tap.
3. Switch the power on with the boiler's on/off switch.
The start-up program will start and cannot be interrupted. During the
program, all segments of the display are shown briefly.
4. Set the components (thermostats, control) so that heat is demanded.
Important
In the event of an error during the start-up, a message with the
corresponding code is displayed. The meaning of the error codes
can be found in the error table.
7.2.1

Adjusting to a different gas type

1 Quinta Ace 30 - 45 - 55 - 65 - 90
2 Quinta Ace 115
The factory setting of the boiler is for operation with the natural gas group
G20 (H gas).
Adjustment range 30
1000 Rpm 7000 4100
Rpm
1400 Rpm 7000 4100
Rpm
1400 Rpm 4000 1550
Rpm
1000 Rpm 4000 2500
Rpm
Warning
Only a qualified installer may carry out the following operations.
Before operating with a different type of gas, carry out the following steps.
45 55 65
5400 5100 5600
5400 5100 5600
1550 1600 1600
2500 2500 2500
7684359 - v.06 - 10012019
90 115
6300 6800
6300 6800
1600 1750
2500 2500