Resetting Or Restoring Settings; Resetting The Configuration Numbers Cn1 And Cn2; Carrying Out An Auto Detect; Restoring The Commissioning Settings - REMEHA Gas 210 Ace 80 Service Manual

4 Installer instructions
4.7

Resetting or restoring settings

4.7.1

Resetting the configuration numbers CN1 and CN2

Fig.21 Configuration numbers
A
11:20 ... ..... .... ...... .... ...... ....
.......
B
............ ....... ....... ....
......... ... .............. ...... .. .....
.......
C
... .
... .
........
4.7.2

Carrying out an auto detect

4.7.3

Restoring the commissioning settings

18
The configuration numbers must be reset when indicated by an error
message or when the control unit has been replaced. The configuration
numbers can be found on the data plate of the appliance.
Important
All custom settings will be erased when the configuration numbers
are reset. Depending on the appliance, there can be factory set
parameters to enable certain accessories.
Use the saved commissioning settings to restore these settings
after the reset.
If no commissioning settings were saved, write down custom
settings before resetting. Include all relevant accessory related
parameters.
> Advanced Service Menu > Set Configuration Numbers
Use the rotary knob to navigate.
Use the
A Select the control unit
B Extra information
C Configuration numbers
1. Press the
2. Select Advanced Service Menu.
3. Select Set Configuration Numbers.
4. Select the device you want to reset.
5. Select and change the CN1 setting.
6. Select and change the CN2 setting.
7. Select Confirm to confirm the changed numbers.
AD-3001385-01
The auto detect-function scans the installation for devices and other
appliances connected to the L-Bus and S-Bus. You can use this function
when a connected device or appliance has been replaced or removed
from the installation.
> Advanced Service Menu > Auto Detect
Use the rotary knob to navigate.
Use the
1. Press the
2. Select Advanced Service Menu.
3. Select Auto Detect.
4. Select Confirm to carry out the auto-detect.
This option is only available when the commissioning settings were saved
on the control panel and allows you to restore these settings.
> Advanced Service Menu > Revert commissioning settings
Use the rotary knob to navigate.
Use the
1. Press the
2. Select Advanced Service Menu.
3. Select Revert commissioning settings.
button to confirm your selection.
button.
button to confirm your selection.
button.
button to confirm your selection.
button.
7837115 - v.01 - 10012023