User Authentication (Optional) - W&H Lyla Instructions For Use Manual

SET THE DISPLAY BRIGHTNESS
To change the display brightness:
On the homepage, tap
1
Tap or to change the value.
2
Tap to confirm and go back to the previous page.
3
CONNECT TO A NETWORK
If you connect through an Ethernet cable, in most cases the sterilizer
will connect to the network automatically. If it does not connect
automatically, or if you are using a Wi-Fi dongle key, follow the
following procedure under supervision of your IT manager / network
administrator.
On the homepage, tap
1
If the connection is through the Ethernet cable, tap
2
TCP/IP screen appears.
If the connection is through Wi-Fi key, tap
3
sterilizer shows the available networks found. Choose the
network, enter the credentials in the further screen, then tap
to confirm: the TCP/IP screen appears.
Note: the and
means (cable or Wi-Fi key) are not properly plugged.
Lyla | Instructions for Use | RIN-210 ENG Rev02 | 15/09/2022 | © W&H Sterilization Srl
> > >
> > .
: after a while, the
icons are disabled if the connectivity
Note: in the TPC/IP screen, the
make any change. The Wi-Fi icon at the bottom isn't visible if
you connect through Ethernet cable.
If your network supports dynamic IP addresses (ask your
4
IT manager), enable the options Dynamic both in IP
Configuration and in the DNS Configuration fields, then tap
to confirm: all entry fields are disabled.
If your network does not support dynamic IP addresses (ask
5
your IT manager), enable the options Static both in IP
Configuration and in the DNS Configuration fields. Tap on each
entry field and enter the IP addresses (ask your IT manager for
details). Then tap

User authentication (optional)

: the
FUNCTION AVAILABILITY
To access the user management functions the User Management
activation code must be entered. The activation code is required only
at the first access to the User Management (
) menus: after the code was entered, the function is enabled and
there is no need to enter the code again.
To acquire the activation code please refer to the Activation code
instructions.
icon is visible only if you
to confirm.
) or the Options (
Getting started
31