4-6.5.3 Superio Device - SOLTEK SL-85ERV4-R Manual

SL-85ERV4-R/85ERV4-RL

4-6.5.3 SuperIO Device

Choose "SuperIO Device" in "Integrated Peripherals" and press <Enter>.
The following sub-screen will appear for SuperIO Device configuration:
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DM A
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART Mode Select The serial port 2 on your system may offer a va-
UR2 Duplex Mode If IrDA or ASKIR is selected, UR2 Duplex Mode
Onboard Parallel Port This item allows you to determine onboard parallel
Parallel Port Mode Select an operating mode for the on-board parallel
ECP mode Use DMA Select a DMA channel for the port when you choose
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Device
Select Enabled if your system has a floppy drive
controller (FDC) installing in the system board and
you want to use it.
Choices: Enabled; Disabled
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports.
Choices: Disabled; Auto;
riety of infrared port modes. Click here for a de-
scription of various modes.
The choices: Normal; IrDA; ASKIR; SCR
should be configured to Half or Full.
Choices: Half; Full
port controller I/O address setting.
Choices: 378H/IRQ7; 278H/IRQ5; 3BC/IRQ7; Dis
abled
(printer) port.
Choices: SPP; EPP; ECP; ECP+EPP;
ECP or ECP+EPP mode for the Parallel Port Mode.
Choices: 1; 3
Enabled
Auto
Auto
Normal
Half
378.IRQ7
SPP
3
3F8/IRQ4; 2F8/IRQ3;
3E8/IRQ4; 2E8/IRQ3
63
Chapter 4 BIOS Setup
Item Help