Usb 2.0 Driver Installation - SOLTEK SL-85ERV4-R Manual

SL-85ERV4-R/85ERV4-RL

3-4 USB 2.0 Driver installation

USB2.0 Driver is typically for Windows 98SE/ME. For Windows 2000/
XP, users can install their latest Service Pack instead of the USB2.0
driver to gain the USB2.0 support. For the Windows 98se/Me, users
must install the USB2.0 driver to activate the USB2.0 support:
1. Following the procedures of opening the Support CD, click to choose
"VIA USB 2.0 Driver" to proceed. Please notice that the USB card
driver is different from the USB 2.0 driver typically for the on-board
USB. Do not use the USB card driver here.
2. Instantly the "USB 2.0 Setup Program"
will pop up on screen. Click "Next" to
continue.
3. Instantly, next screen will pop up to
prompt you to select component. Select
"Install USB Driver" and click "Next"
button to continue.
4. The USB 2.0 Setup Program will then
guide you through the whole driver setup
until the "Finish" screen appears to
prompt you to restart your system.
Please click "Finish" button to restart
system to put the new driver into effect.
Chapter 3 Software Setup
38
Next
Next
Finish