Overview; Ina260Evm-Pdk Contents - Texas Instruments INA260EVM-PDK Instruction Manual

Overview

1 Overview
The INA260 is a high- or low-side current sensor, power, and voltage monitor with a 2-mΩ precision integrated
2
shunt resistor and I C interface. The INA260 offers programmable conversion times and averaging modes that
enable high resolution measurements of the current, voltage, and power dissipation of the monitored source.
The INA260EVM-PDK, which consists of the INA260EVM and SM-USB-DIG controller board, is a platform
used to evaluate the features and performance of the INA260 under various signal and supply conditions.
This document gives a general overview of the INA260EVM-PDK and describes the features and functions to
consider when using this evaluation module.

1.1 INA260EVM-PDK Contents

Table 1-1 summarizes the contents of the INA260EVM kit.
Texas Instruments customer support center
This EVM kit requires the INA260EVM GUI software, which is available for download through the
INA260 design & development
website at www.ti.com
INA260EVM PCB test board
SM-USB-DIG platform PCB
2 INA260EVM-PDK (Rev A)
if any component is missing.
folder. TI recommends users check the
to verify that they have the latest versions of the related software.
Table 1-1. INA260EVM Kit Contents
ITEM
USB extender cable
Copyright © 2023 Texas Instruments Incorporated
Figure 1-1 shows all included hardware. Contact the
Note
INA260 product folder
QUANTITY
1
1
1
SBOU180A – NOVEMBER 2016 – REVISED MARCH 2023
www.ti.com
on the TI
Submit Document Feedback