Ina260Evm Gui Software - Texas Instruments INA260EVM-PDK Instruction Manual

www.ti.com
Additionally, the supply voltage (V
necessary (see Figure 3-7).
With the INA260 powered on, the user can enable the analog input sources.
Section 4 discusses the GUI configuration and data collection using this setup.

4 INA260EVM GUI Software

The INA260EVM GUI is a collection of software tools that make it easy for the user to explore the key behaviors
of the INA260. The following tools are available:
• The Configuration tool simplifies the INA260 setup prior to evaluation testing
• The Graph tool plots the acquired data and exports to a file, if necessary
• The Registers tool displays and modifies the contents of the user-accessible registers
Each tool has a dedicated page under the corresponding tab on the GUI. The tabs are organized intuitively from
left to right in the proper order, and the GUI always displays the Configuration page immediately after start-up.
User can monitor measurement data under the Results Bar at the bottom of the GUI window. In most cases,
(gross) testing can be performed using just the Configuration tool and the Results Bar; users may only need the
Graph and Registers tools in special situations.
SBOU180A – NOVEMBER 2016 – REVISED MARCH 2023
Submit Document Feedback
) is set to 3.3 V by default, but the user can select the 5-V option, if
DUT
Figure 3-7. V
DUT
Copyright © 2023 Texas Instruments Incorporated
Selection
INA260EVM GUI Software
INA260EVM-PDK (Rev A) 23