Supermicro SuperServer SYS-521E-WR User Manual page 91

Note: Do not interrupt this process until the BIOS flashing is complete.
9. The screen above indicates that the BIOS update process is complete. When you see the
screen above, unplug the AC power cable from the power supply, clear CMOS, and plug
the AC power cable in the power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load the default settings.
12. After loading the default settings, press <F4> to save the settings and exit the BIOS Setup
utility.
Chapter 7: Troubleshooting and Support
91