Breadboard Area; Jtag Emulation Port; Jumper Settings - Analog Devices ADSP-21161N EZ-KIT LITE Manual

4.2.5 Breadboard Area

Use the breadboard area to add external circuitry.
• All board voltages and grounds
• Package Footprints
o 1x SOIC16
o 1x SOIC20
o 4x SOT23-6
o 1x PSOP44
o 2x SOT23
o 27x 0805
Warning: Any circuitry added to the breadboard area is not supported.

4.2.6 JTAG Emulation Port

The JTAG emulation port allows an emulator to access the DSP's internal and
external memory, as well as the special function registers through a 14-pin header.
See section 4.5.5
about available emulators, contact Analog Devices (See section 1.1).
4.3

Jumper Settings

This section describes the function of all the jumpers. The following figure shows
the location of all the jumpers.
ADSP-21161N EZ-KIT Lite Evaluation System Manual
for more information about the JTAG connector. To learn more
4-4