Example Programs; Using The Flash Programmer Utility - Analog Devices ADSP-21161N EZ-KIT LITE Manual

The Microphone and Line-In jacks connect to the left and right ADC1 channel on
the AD1836, depending on the setting of jumpers. See sections
for more information about configuring the jumpers. Two RCA jacks connect to
ADC2 on the AD1836. This input is configured though the input mode selection
jumpers see section
The Line-Out jacks connect to the left and right DAC outputs of the AD1836 and
AD1852.
The CS8414 has an error flag (VERF) that is used to indicate that the audio output
may not be valid. This signal is connected to an LED (LED9) on the board. This
signal may also be used by interpolation filters to provide error correction.

3.8 Example Programs

Example programs are provided with the ADSP-21161N EZ-KIT Lite to
demonstrate various capabilities of the evaluation board. These programs are
installed with
\...\VisualDSP\211xx\EZ-KITs\ADSP-21161N\Examples.
example program readme files for more information.

3.9 Using the Flash Programmer Utility

The ADSP-21161N EZ-KIT Lite evaluation system includes a flash programmer
utility. The utility allows you to program the flash on the EZ-KIT Lite. This
utility must be installed separately from the debug software. To install the utility,
insert the EZ-KIT Lite CD-ROM and follow the steps in the installation wizard.
For more information on the flash programmer utility, from the start menu choose
Programs\VisualDSP\Flash Programmer Help.
ADSP-21161N EZ-KIT Lite Evaluation System Manual
4.3.7 for more information.
the EZ-KIT Lite software and can
Please refer to the
4.3.9 and 4.3.8
be found in
3-6