NovaStar MX Series User Manual page 11

Area Content
Input HDMI1, HDMI2, DP,
SDI1, SDI2, Internal
Internal
1920×1080@144Hz
Screen 1920×1080@144.00Hz
Port 1–10
OPT 1–2
Bottom Sync:HDMI@143.86Hz
line
SDR
www.novastar.tech
Description
The device input source type and status

Green: The signal is accessed normally and used.

Blue: The signal is accessed normally, but not used.

Red: The signal is abnormal.

Gray: The signal is abnormal and not used.
For related operations in the Send-Only Controller working mode, please
refer to 5.1.1 Set Input Source.
The resolution and frame rate of the currently available input source
If multiple input sources are available, the resolution and frame rate of each
input source will be displayed one by one. If the input is used by the layer, the
layer number will be displayed below.
For related operations, please refer to
(HDMI1, HDMI2 and DP only).
The screen resolution and frame rate
The screen brightness
For related operations, please refer to
The statuses of the Ethernet ports

Blue: Connected

Gray: Disconnected
The statuses of the OPT ports

Blue: Connected

Gray: Disconnected
The sync signal currently used and the signal status

Sync: Active Input: Sync with the frame rate of the current input source

Sync: Genlock: Sync with the frame rate of the Genlock signal

Sync: Internal: Sync with the frame rate of the internal clock of the device
Color code:

Blue: The signal is normal.

Red: The signal is abnormal.
For related operations, please refer to
The format of the dynamic range
For-related operations, please refer to
only).
The output display status.
For related operations, please refer to

: The display is frozen.

: The display is blacked out

When no icon is displayed, the display is normal
The temperature inside the chassis
MX30 LED Display Controller User Manual
6.2.2 Set Resolution and Frame Rate
6.4.1 Adjust Screen Brightness.
6.4.5 Set Sync Source.
6.2.4 Set HDR Parameters (HDMI1
7.5 Control Display Status.
8