Initial Startup Of The Access Controller Module; Setting Up A Configuration Environment; Connecting The Console Cable; Setting Terminal Parameters - H3C LSQM1WCMB0 Quick Start Manual

Pivot the ejector levers toward the front panel to lock the access controller module
4.
in place.
Using a Philips screwdriver, fasten the captive screws on the access controller
5.
module.
If the switch is powered off, power on the switch.
6.

Initial startup of the access controller module

Setting up a configuration environment

Set up a configuration environment by connecting the console port of the
LSQM1WCMB0 access controller module to a console terminal, a PC in this example.

Connecting the console cable

Connect the DB-9 female connector of the console cable to the serial port of the
1.
PC.
Connect the RJ-45 connector of the console cable to the console port of the
2.
LSQM1WCMB0 module.

Setting terminal parameters

Before configuring your access controller module through a console terminal, a PC
running Microsoft Windows XP, for example, set the following parameters for the console
terminal:

Bits per second: 9600

Data bits: 8

Parity: none

Stop bits: 1

Flow control: none

Terminal emulation: VT100 or Auto detect.
To set these parameters:
Start the computer and select Start > Programs > Accessories > Communications >
1.
HyperTerminal. The Connection Description dialog box appears.
8