Table of Contents
Advertisement
Defining the IP address on the Processor Unit network
adapter for communication with the transceiver
The computer and the transceiver(s) communicate on a high capacity Ethernet cable.
If you use more than one transceiver, a high capacity Ethernet switch is required. On
the computer, define the IP address and Subnet mask for the Ethernet port used to
communicate with the transceiver(s). The CP60 system automatically assigns an IP
address to a transceiver that is turned off and on.
Prerequisites
This procedure is made for the Microsoft
that you are familiar with this operating system.
Context
As long as you do not replace the Processor Unit with another computer, or change the
network adapter, you only need to do this once.
Procedure
1
On the computer, close the CP60 program.
2
Open the
Network Connections
a
In the bottom-left corner of your desktop, select the Windows
b
In the search box, type "Network Connections", and open the
Connections
3
Right-click the network adapter you are going to use and select
shortcut menu.
4
On the list of connections, select
5
Select
Use the following IP address
•
: 157.237.14.12
IP Address
Any address can be used, but 157.237.15.12 is recommended for legacy reasons.
This is particularly important if your system contains old GPT transceivers.
•
: 255.255.0.0
Subnet mask
You can leave
saying that the message subnet mask is missing, select
subnet mask is then automatically generated.
6
Select
to save the selected settings, and then close all the dialog boxes.
OK
7
Start the CP60 program.
8
Open the
Transceiver Installation
a
Open the
Setup
b
On the
Setup
c
On the left side of the
110-0006927/A (Preliminary)
Preliminary version 2022-07-26
®
Windows
dialog box.
dialog box.
Internet Protocol 4 (TCP/IPv4)
, and type the IP address and network mask.
blank and select
Subnet mask
page.
menu.
menu, select
Installation
Installation
®
10 operating system. It is assumed
. When you see an error message
OK
OK
.
dialog box, select
Transceiver
Setting to work
®
search function.
Network
on the
Properties
, and then
.
Properties
again. A default
.
125
Advertisement
Table of Contents
