RS-232 serial line connection using three wires
An RS-232 serial line connection using NMEA datagrams is a common way to connect
the CP60 system to external devices.
A
Local connection
B
Connection on remote device For more information,
refer to the end-user documentation provided by the
manufacturer.
C
Female 9-pin D-Subminiature connector
D
Male 9-pin D-Subminiature connector
Unless otherwise specified, this cable must be provided
by the installation shipyard. Note that this cable does not
support all the signals in the standard RS-232 specification.
Minimum cable requirements
•
: 2 x 4 x 0.5 mm
Conductors
•
: Overall braided
Screen
•
: 60 V
Voltage
•
Maximum outer diameter
If you need to install a very long cable, increase the cross section.
Related topics
Cable layout and interconnections, page 68
Cable drawings and specifications, page 93
110-0006927/A (Preliminary)
Preliminary version 2022-07-26
2
: Defined by the plugs and/or the gable gland
Cable layout and interconnections
95