Table of Contents
Advertisement
Simrad CP60 Installation Manual
Reducing electrical noise
These points must all be considered to reduce electrical noise on an CP60 system.
Note
The information here must be considered as general advice.
• Place the transducer cables in a metal conduit all the way from the transducer to
the transceiver. Terminate the conduit as close to the transducer and transceiver as
possible.
• Make sure that the transducer cables are completely separated from other cables,
boxes, other potential noise sources.
• Make sure that all units are properly grounded.
• Use shielded cables with correct grounding.
• Separate the cables used by the CP60 system from other cables with high voltages,
large currents or transients. Place all high voltage power cables in metal conduits.
• If you more than one Wide Band Transceiver (WBT), install these in such a way that
the transducer cables have the maximum distance to the power and Ethernet cables.
• Ensure maximum physical distance between the transceiver and the power supply.
• Ensure maximum physical distance between each power supply.
• If possible, install the transceivers in a sonar room that is electrically shielded.
Related topics
Cable layout and interconnections, page 68
70
Preliminary version 2022-07-26
110-0006927/A (Preliminary)
Advertisement
Table of Contents
