Table of Contents
Advertisement
d
Choose which channel to use as source for the depth information.
"Best practice" is to use the lowest frequency. In this context, the term channel
is used as a common term to identify the combination of transceiver, transducer
and operating frequency.
e
If applicable, specify a dedicated Talker ID.
f
Select
Inspect Port
The
Inspect Port
communication parameters. To do this, you must open the
LAN Port Setup
g
Select
OK
9
If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters, use
the
page. The
I/O Setup
dialog boxes.
10 Make sure that there is data traffic on the output port (shown in the
The
Port Monitor
), and one for outgoing messages (
Data
knowledge of the data communication to investigate the datagrams. The
dialog box is a tool for debugging purposes. It is neither required nor
Monitor
intended for normal operation of the CP60 system.
11 Select
and then
Apply
box.
Related topics
Setting to work, page 108
Interfacing peripheral equipment, page 146
Exporting sensor data to a peripheral system
The information provided to the CP60 system from various sensors can also be useful for
other systems on board. The CP60 system allows you to export the same sensor data that
was originally imported. This can "reuse" the same information on other systems. The
page is used to set up and control this export functionality.
Relay Output
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
110-0006927/A (Preliminary)
Preliminary version 2022-07-26
to check the communication parameters on the chosen port.
function does not allow you to set up or change any
dialog box from the
to save the selected settings and close the dialog box.
page is located in the
I/O Setup
dialog box provides one text box for incoming messages (
to save all the parameters and close the
Close
page.
I/O Setup
Inspect Port
Installation
). Use these boxes and your
Tx Data
Setting to work
or
Serial Port Setup
.
and
Output
box).
Tx Data
Rx
Port
dialog
Output
163
Advertisement
Table of Contents
