Filtering Tips - Broaster G Series Operation Manual

FILTERING TIPS

COMPLAINT
Motor will not start
Turn cook/
filter switch
to OFF position to avoid
splashing of oil when
motor protector reset but-
ton is pushed.
Motor hums but will not
start
Motor starts but will not
pump
Motor starts but will not
pump or stops at any level
Motor starts but stops
pumping when oil is level
with top of hold down,
approximately 1 inch of oil
in bottom
CAUSE
1. Overload tripped
2. Cook/filter switch OFF
3. Open or faulty wall fuse
or circuit breaker
1. Solidified shortening in
pump
2. Crumbs in pump
1. Filter pan not completely
installed
2. O-ring on riser line not
installed
3. Solidified shortening in
piping or filter pan
1. Filter paper or hold down
improperly installed
2. Not using enough
®
Broaster filtering com-
pound
1. Filter paper improperly
installed or crumbs under
filter paper or hold down
12-7
broaster.com Manual #20932 05/19
REMEDY
1. Wait for overload to cool.
Push red motor protector
reset button located on
rear of motor.
2. Turn to FILTER
3. Check wall fuse or circuit
breaker
1. Turn cook/filter switch
OFF. Contact service
person.
2. Turn cook/filter switch
OFF. Contact service
person.
1. Firmly push filter pan in
2. See FILTERING
3. Turn cook/filter switch
OFF. Contact service
person.
1. See COOKING OIL CARE
AND FILTERING
2. Next filtering cycle, make
sure proper amount of
®
Broaster filtering com-
pound is used
1. See COOKING OIL CARE
AND FILTERING