Table of Contents
Advertisement
Solid State Temperature Sensor Loca-
tion:
Slowly agitate brush in oil to dislodge
any crumbs caught in it. Rinse cooking
well using oil remaining in brush when
dipped in oil. Drain remaining oil and
crumbs. Pull cover over cooking well
but DO NOT CLOSE. Turn cook/filter
switch to FILTER. After 5 minutes,
push cover assembly toward the rear
of the unit. Close drain valve.
5.
When air bubbles appear turn cook/fil-
ter switch OFF.
Be sure hot oil is at HOT
OIL LEVEL. Be sure top
heating element is covered before turn-
ing cook/filter switch to COOK.
6.
When filter pan has cooled, remove
and discard filter paper and filtering
compound. Using a clean cloth or
paper towel, wipe crumbs from filter
hold down, filter pan interior and top &
bottom of filter pan cover. Never use
soap and water.
fire if exposed to heat. Laundering will
not remove the oil. Dispose of all oil-
soiled papers and rags in a trash con-
tainer that is in a ventilated area away
from all cooking equipment or other heat
sources such as direct sunlight.
ter pan cover in its proper position. Filter
pan cover must be wiped clean after
each filtering cycle.
7.
FILTERING HINTS
1.
2.
of oil if motor protector reset button is
used.
9-3
broaster.com Manual #20932 05/19
Rags or papers contain-
ing cooking oil can catch
DO NOT
without filter pan and fil-
Return clean Filter Pan (equipped with
all necessary clean filter components
including cover) under the fryer before
operation.
Never allow solid shortening to solidify
in filter pan or lines.
For maximum filtration, recirculate oil.
When hot oil is drained into filter pan,
turn cook/filter switch to FILTER. Let
motor run for five minutes with drain
valve open. This could extend useful
oil life.
Ensure cook/filter switch
is OFF to avoid splashing
operate unit
Advertisement
Table of Contents
