Table of Contents
Advertisement
alert will signal that the cooking cycle is
complete.
Automatic Oil Replenish:
Thirty seconds after the cook cycle has
ended, the fryer will determine if the oil level
needs to be replenished. If the sensor indi-
cates it needs to be replenished, the mes-
sage above will be displayed. The replenish
valve will open and the pump will run for 10
seconds.
Automatic Oil Filtering
After the oil replenishment sequence, the
isolation valve will open and the pump will
begin circulating the oil through the filter
housing for the preprogrammed amount of
time. The display will show the message
above. The filtration cycle will finish auto-
matically after an evacuation sequence that
occurs for a preprogrammed amount of
time. The length of filtering time and the
evacuation sequences can be changed as
required. Refer to the SETUP tab instruc-
tions.
Loads Cooked:
This box indicates how many cook cycles
have been completed while automatically
filtering. The value may be reset to zero by
tapping the box twice. This should be reset
after removing crumbs from the filter hous-
ing. It serves as a reminder of how full the
filter housing may be with crumbs. After
6-4
broaster.com Manual #20932 05/19 Rev: 05/19
using the fryer for a while it will become
apparent how many loads will fill the filter to
the point that it needs to be emptied.
Cycles Since Last Filtered (Automatic Fil-
tering Disabled):
It is recommended the oil should be filtered
every 5 loads.
This box indicates how many cook cycles
have been completed since the last time
the oil was filtered. It is active and can be
pressed at any time to go to the filter dis-
play except during a cooking cycle. Once
you reach a preset number of cycles, you
will be shown a filter options screen. If a fil-
ter cycle is bypassed the next cycle will turn
red and start flashing.
This number can be changed and the pro-
cedure will be explained in the Setup Tab
section.
Advertisement
Table of Contents
