Table of Contents
Advertisement
MANAGE OIL TAB
This tab is the manage oil tab and has three
buttons; a Filter Oil button, a Send used oil
to bulk storage tank button, and a Fill with
new oil from bulk storage tank button.
Filter Oil
There are also two reminders to observe
before filtering the oil. SEE SECTION 9 -
COOKING OIL CARE AND FILTERING
before starting the pump motor.
When the Start Pump button is pressed the
filter running display appears as shown
below. Press Open Drain Valve to allow the
oil to recirculate. The button will change to
say Close Drain Valve.
The timer in the middle of the screen starts
counting up. When it reaches 5:00 minutes
an alert sounds and a reminder flashes. To
silence the alert press the button with the
speaker on it.
6-5
broaster.com Manual #20932 05/19 Rev: 05/19
Press Close Drain Valve after the oil is fil-
tered to your satisfaction.
Press STOP PUMP to end filtering after all
the oil has returned to the cooking well.
A CAUTION message will appear whenever
the filter pan is not in place. For safety pur-
poses, the drain valve can only be opened
by pressing and holding the Open Drain
Valve button for 3 seconds when the filter
plan is not in place. Press Close Drain Valve
to close the drain valve.
The above procedure is intended for the
purpose of draining cleaning fluid from the
cooking well. Draining hot oil from the
cooking well should be avoided for safety
reasons.
To return to the Cook Tab, press the button
indicated by the X in the upper left corner.
The Caution Display will appear advising
the oil level be checked. If the oil level is OK
press the green OK button.
Advertisement
Table of Contents
