Table of Contents
Advertisement
5.
Clean O-ring groove and cover top
and bottom. Use O-ring tool #12791 to
clean O-ring groove. Use a non-metal-
lic heavy duty commercial scouring
pad that is USDA approved to clean
cover.
6.
Remove any oil or grease build-up
from Pressure Relief Valve and Pres-
sure Gauge Ports on bottom of cover.
7.
After cleaning, completely dry. Lubri-
cate O-ring with clean liquid shorten-
ing. Install O-ring in O-ring groove.
SPLASH SHIELD
Allow cover assembly to
cool before cleaning. Hot
surfaces could cause serious burns.
If your unit is equipped with a two piece
splash guard, clean it according to the fol-
lowing instructions:
1.
OPEN cover and slide back 2 to 3
inches.
2.
Rotate cover handle (1) to a centered
position.
3.
Loosen screws (2) attaching back
splash shield (3) to splash shield (4).
4.
5.
shield (4) are assembled correctly after
cleaning. The cover may not close cor-
rectly if they are not.
6.
Filter Pan & Cover
Wipe all oil off filter pan and both sides of
the filter pan cover.
fire if exposed to heat. Laundering will
not remove the oil. Dispose of all oil-
soiled papers and rags in a trash con-
tainer that is in a ventilated area away
from all cooking equipment or other heat
sources such as direct sunlight.
10-3
broaster.com Manual #20932 05/19
Slide splash shield (4) forward and up
towards the end of the cover handle
(1).
Clean the top and underside of splash
shield and top of the cover.
Make sure back splash
shield (3) and splash
Assemble in reverse order.
Rags or papers contain-
ing cooking oil can catch
Advertisement
Table of Contents
